Searon LED Battery Status Charge Indicator Monitor Meter Gauge Level Indicator Tester for Motorcycle Golf Carts Car Jet Ski

Price: from $20.99

Please choose from the options above to see price and availability.

CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED 'AS IS' AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.

Manufacturer Description

Product Features
- 10 segment LED bar graph display
- High reliability
- LED flashes for low charge warning
- Memory option to recall last chage

Notice
Please connect the correct voltage to your battery indicator as noted on your model . Failure to connect to the correct voltage will damage the batery indicator causing it to function abnormally.

Reset Procedure
- This battery indicator is equipped with a memory recall feature. If you are connected the meter through a key switch, you will need to reset the meter during the charging cycle. You will need to have the indicator switched to the"ON" position while charging for approximately 6 minutes. This will clear the memory and reset the meter back to "Full".
- High Voltage Reset (HVR): A HVR reset happens when the meter is switched to the "ON" position while charging the batteries. The meter needs the higher voltage from the charger for at least 6 continuous minutes to reset.
- Open Circuit Reset(OCR): An OCR reset is done by disconnecting the meter from power and leaving it for 10 minutes . Upon reconnecting of a battery, the meter will reset.

Troubleshooting Tips
- Meter scans from full to empty then shuts off.
- This occurs if your "C" terminal is not connected, make sure your "C" terminal is either connected to the Battery "+" or a Key switch.

Battery Indicator level is stuck after full charge
- This is a common problem with a key switch connection and the meter is not turned to the "full" position while charging for at least 6 minutes. This is because the meter is equipped with a battery recall feature.

Do not use a mementary switch with the meter.

Product Features

Please read the instructions carefully before the meter is connected. otherwise you will mistake that the meter is a defective one. Led battery indicator 10 segment LED bar graph display for Lead-acid only Make sure your "C" terminal is either connected to the Battery "+" or a Key switch, otherwise, meter scans from full to empty then shuts off The meter is equipped with a battery recall feature and not turned to the "full" position while charging for at least 6 minutes Please connect the correct voltage to your battery indicator as noted on your model . Failure to connect to the correct voltage will damage the batery indicator causing it to function abnormally

Write a Review